¿Cómo mejorar la calidad de los productos adhesivos termofusibles?


La fórmula deadhesivo termofusible is not static, and some raw materials can be used to improve the quality of adhesivo termofusible products.

1. Lubricante

Appropriate addition of lubricants in adhesivo termofusibles can improve the release performance of the plastic during heating and molding, and improve the surface finish of the product. But this kind of lubricant should not be added too much, so as not to affect the viscosity of the product. Commonly used lubricants include stearic acid, salt, paraffin wax, synthetic wax and so on.

2. Agente colorante

Colorants are used to change the color of adhesivo termofusibles. The main purpose is to beautify and decorate. About 80% of plastic products are colored to produce the final product.

3. Embalaje

Adding fillers to the adhesivo termofusible can reduce the shrinkage of the adhesivo termofusible, increase the viscosity, increase the gap-filling property, and reduce the cost at the same time. Adding too much filler will affect the fluidity of the adhesivo termofusible and reduce its adhesion. Common fillers are calcium carbonate, barium sulfate and clay.

4. Retardante de llama

The main component of adhesivo termofusible is polyurethane resin, which is combustible. We can improve the flame retardancy of adhesivo termofusible by adding flame retardant in the middle. Most plastics containing flame retardants are self-extinguishing or burn very slowly. Commonly used flame retardants are antimony dioxide, aluminum boron compounds, tetrachlorophthalic anhydride and so on.